![]() ![]() Updated Samba to address security vulnerabilities.Fixed Network checksum issue on 4-bay units using bonding.Updated OpenSSL to address security vulnerabilities.We recommend that you update your ReadyNAS to this latest RAIDiator release to ensure your ReadyNAS is running with all the latest bug fixes and enhancements. The simplest way to update is to use the System/Update/Remote tab in FrontView. NETGEAR is pleased to announce the release of RAIDiator 4.2.27 (x86), the latest firmware for the following ReadyNAS network attached storage products: Fixed "ShellShock"-related security vulnerabilities.Fixed ADS domain logins over AFP immediately after joining the domain.If you prefer, you can choose to do a local update by first downloading the new image here: RAIDiator-arm-5.3.11. ![]() The simplest way to update is to use the System/Update tab in Dashboard. NETGEAR is pleased to announce the release of RAIDiator 5.3.11 (ARM), the latest firmware for the following ReadyNAS network attached storage products: ReadyNAS 104, 104, and 2120 only support volumes up to 16TB.ReadyNAS 102, 104, and 2120 only support creating iSCSI LUNs 8TB and smaller.After sometime, the UPS will start reporting the correct information. UPS may report incorrect status after reboot, it may send out a warning during this time.If these steps are not followed then you may develop errors on the file system on the USB device. If you wish to remove a USB storage device, you should follow the safe removal procedure of first unmounting before removing the USB device.If a Flex-RAID volume has been expanded, the volume cannot be switched back to X-RAID mode.After that, the encrypted volume is displayed as inactive. If USB key is missing for encryption, the user has to wait on a 10 minute timeout.If the USB key is missing from the system for Encryption, there is no error message presented.Can't set up bond on interfaces that are not already connected.Deleting volume with ReadyNAS Vault enabled will show error.Disk failure on the 32 will not show LED failure for the exact drive that has failed, use local web admin page for disk failure information.WOL will not be supported on 3220/4220 at this time for 10GbE.After deleting a volume and creating a new one the old volume may still show up until after a reboot.Fixed defragment operation so it doesn't try to defragment snapshot.Avoid potential flash corruption on some desktop x86 models after update.Added UI option to configure sync policy for iSCSI LUNs.Various security updates (OpenSSL, GNUTLS, kernel).Prevents issue with too many open file descriptors in few Active Directory environments.Added support for Richcomm-based UPS devices.Updated kernel with various filesystem and iSCSI improvements.x86 (version 4.2.27) for Pro Pioneer / Pro Business / Pro 2 / Pro 4 / Pro 6 / NVX / Ultra 2 / Ultra 4 / Ultra 6 / Ultra 2 Plus / Ultra 4 Plus / Ultra 6 Plus / 1500 / 2100 / 3100 / 3200 / 4200.Note: Image downloads are zipped and must be unzipped before being uploaded into your ReadyNAS.Äownloads for latest ReadyNAS OS6 devices: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |